DARVAN® 7-N

Dispersing Agent

Category:

DARVAN® 7-N is recommended for use in the preparation of casting slips made from whiteware and refractory compositions, producing slips with a wide casting range. The slips show little tendency to thicken on standing, or to become thixotropic. Ware cast from these slips is very plastic and easy to “scrap”.

Most whiteware bodies are readily dispersed by the addition of 0.2 to 1% of DARVAN 7-N, based on dry body weight. During the casting process, very little DARVAN 7-N is absorbed by the molds and, under most factory conditions, a good casting slip can be made from 100% scrap just by adding water to give the desired fluidity. Compared to the use of sodium silicate and soda ash, DARVAN 7-N enables longer life for plaster molds.

Both drain and solid castware made from slips containing DARVAN 7-N can be left in the molds for long periods of time without cracking. Hobbyware consisting of difficult shapes is made successfully on a commercial scale by leaving the ware in the molds for 6 to 24 hours. If the ware is to be left in the mold for a long time, the drain hole in the mold must be covered or the mold inverted onto a flat surface in order to prevent surface drying around the drain hole. A long set in the molds produces ware that is very easy to handle, and decreases the tendency of large pieces, e.g. vases, planters or sanitaryware, to warp or distort while drying. Ware made from slips containing DARVAN 7-N can also be removed from the molds in the usual time of one to two hours, with the exception of heavy types of solid casts.

DARVAN 7-N provides sprayed glazes with outstanding viscosity stability. In ceramic compositions it can be used where sodium oxide is not detrimental, such as casting of barium titanate, zirconium oxide and aluminum oxide. In spray-dried bodies, in addition to its dispersing properties, it can be used as a binder at levels of about 2%.

DARVAN 7-N has been tested in various applications as a grinding aid. Depending on the application, 0.005% to 0.1% has been reported to help dry grinding.

Safety Data Sheet

Sales Spec Sheet

Step 1 of 2

Please fill out the form below completely.

Continue to Contact / Shipping Information
Step 2 of 2

Contact Info

Are you currently a customer?

Thank you for Requesting a Quote.

A Vanderbilt associate will contact you shortly.

Something went wrong with your submission.

Please refresh the page and try again.

Step 1 of 2

Please fill out the form below completely.

Charges may apply for samples. Sample orders are processed within 5 to 10 business days. If this is an urgent sample request, please specify below and fill out the required information.

Continue to Contact / Shipping Information
Step 2 of 2

Contact Info

Are you currently a customer?

Thank you for Requesting a Sample.

A Vanderbilt associate will contact you shortly.

Something went wrong with your submission.

Please refresh the page and try again.

Please complete this form for your technical questions about our products or how they can best be used in your application.

All fields must be filled in to ensure a timely response by our R & D staff.

Thank you for sending a Technical Question.

A Vanderbilt associate will contact you shortly.

Something went wrong with your submission.

Please refresh the page and try again.